Thanks for the reply.
I tried all the ports, the only port that allows me to communicate at all with
the unit is the J8 Diagnostic port on Ref 0. I also noticed that when I send
the command to change to UTC time, the units go into FAULT mode and it takes
about 5 minutes to relock the GPS.
Mitch.
Message: 1
Date: Wed, 26 Nov 2014 21:13:16 -0600
From: Bob Camp <kb...@n1k.org>
To: Discussion of precise time and frequency measurement
<time-nuts@febo.com>
Subject: Re: [time-nuts] Lucent KS-24361 GPS Time vs. UTC
Message-ID: <50e05f9e-853a-4782-a41c-ea210ccea...@n1k.org>
Content-Type: text/plain; charset=us-ascii
Hi
Which port are you putting the commands into?
The box *may* respond to some things on the Diag port that it does not respond
to on the PPS port. I have not investigated this, but it is a possibility.
Bob
> On Nov 26, 2014, at 12:52 PM, Mitchell Janoff <majan...@verizon.net> wrote:
>
> I now have my KS-24361 operating and I've successfully communicated via RS232
> (using the hack described previously) with both SatStat and GPSCon using
> Win7. The time I'm getting out of the unit is the GPS time (+16 seconds).
> I've tried to convert the time to UTC by first changing the mode from
> continuous output to a manual time update(:PTIM:TCOD:CONT 0), and then
> changing the time to UTC from GPS using the :PTIM:UTC 1 command. Neither of
> these commands seem to work with this unit.
>
> Has anyone experienced this and did you come up with a solution?
>
> Thanks.
>
> Mitch.
>
>
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
