Hi, Attached is a plot of the output frequency difference from 10MHz during warm-up. I believe this indicates the crystal is SC cut.
The VREF and EFC pins on the unit do work. The VREF is 4.1V. I probed around the board of the unit I cracked open and found a low frequency oscillation. It seems to vary from 40 to 90 Hz depending on where the unit is in the warm-up cycle, and what I'm doing to it. With the can cut off, the unit draws almost 50% more power than normal trying to maintain temperature, so it's possible this is offset from what has been reported in normal units. In the photos, you may have noticed two sets of large, unpopulated pads on the board near the output. I experimented with putting 10uF capacitors across those. That killed the output, but the low frequency oscillation could still be detected further back in the circuit. Dan On Sat, Feb 27, 2016 at 1:10 PM, Joseph Gray <jg...@zianet.com> wrote: > Nice teardown. I was looking at that listing just yesterday. I am tempted, > but don't know what I'd do with 40. > > The real question is, how do they perform? > > Joe Gray > W5JG > On Feb 27, 2016 9:48 AM, "Daniel Watson" <watsondani...@gmail.com> wrote: > > > Hi, > > > > I'm sure many of you are tracking the cheap CTS 10MHz OCXOs available on > > eBay right now. I purchased a case of them, and decided to crack one > open. > > I took pictures along the way, thinking that might be interesting to the > > list. Here is the blog post if you are interested: > > > > > > > http://syncchannel.blogspot.com/2016/02/10mhz-ocxo-teardown-cts-1960017.html > > > > Comments on the internal construction of the OCXO are welcome. It seems > > pretty straightforward inside though. > > > > > > Best regards, > > > > Dan W. > > _______________________________________________ > > time-nuts mailing list -- time-nuts@febo.com > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. >
_______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.