I'd be willing to assist with board layout if someone wanted to make
this into a real project (e.g., fully developed schematic). TAPR might
be talked into supplying at least bare boards; we'd have to get a sense
of demand before committing to a full kit or assembled unit.
John
----
On 3/24/2016 9:04 AM, jimlux wrote:
More like $40 in parts, without a board, etc.
The RPD-1 is $20.70
LT1678/LT1679 is a nice low noise opamp that does rail to rail and is
about $5
etc
On 3/24/16 4:42 AM, Bob Camp wrote:
Hi
Pretty simple:
Double balanced mixer, RPD-1 is one option, there are others.
Fairly simple L/C lowpass between the mixer and an op-amp.
20 db positive (non-inverting) op-amp amplifier string after the mixer
Output of the string goes to the sound card. Use a good (dual / quad)
audio op amp
Quadrature amp picks off the output of the first op amp stage, switch
and resistors to set gain, pot to set op point.
====
So what you have is an old style quadrature phase noise amp and “PLL”.
More or less a very junior version
of the 3048 test box. Like any setup of this sort, you check two
similar oscillators. They run in quadrature and
you do a few “measure this with switch in position A” sort of things
to set things up each time.
Nothing exotic.
Bob
Any documentation on this $40 phase noise test set?
Rick N6RK
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
