Most probably this OCXO incorporazes an SC-cut crystal.Due to insufficient 
design it sometimes starts at the so-called B-mode which typically is some 9% 
above the desired C-mode. The motional resistance is abot the same, someimes 
even slightly lower than the resistanxe of the C-mode. It needs a careful 
design to assurevreliable start-up at the desired mode -which sometimes may not 
be the case ...Best regardsBerndDK1AGWww.axtal.com


Von meinem Samsung Galaxy Smartphone gesendet.
-------- Ursprüngliche Nachricht --------Von: Iwa2008 via time-nuts 
<time-nuts@febo.com> Datum: 19.06.16  22:51  (GMT+01:00) An: time-nuts@febo.com 
Betreff: [time-nuts] Ocxo wrong frequency. 

<div id="AOLMsgPart_2_f94d06d3-7bcb-464b-aed2-314f90761f0a">

<div id="AOLMsgPart_2_bea72c74-0991-404a-ad92-fdbd77734860">
</div><div id="AOLMsgPart_2_bea72c74-0991-404a-ad92-fdbd77734860">
Has anyone come across oscillators outputting the incorrect frequency when 
powered up. The frequency that is outputted reads 10.8 Mhz, and falls a few HZ 
as the ocxo warms up. The frequency is stable, even when measured over the 
course of many hours.  It is a repeatable issue, when the ocxo's are powered 
from 2 particular power supplies. Yet when powered on again, they give the 
correct frequency. The affected ocxo's are c-mac units, both nos/"ebay" 
used.</div><div id="AOLMsgPart_2_bea72c74-0991-404a-ad92-fdbd77734860">
</div><div id="AOLMsgPart_2_bea72c74-0991-404a-ad92-fdbd77734860">Thanks, 
</div><div 
id="AOLMsgPart_2_bea72c74-0991-404a-ad92-fdbd77734860">Brendan</div><div 
id="AOLMsgPart_2_bea72c74-0991-404a-ad92-fdbd77734860">
Sent from AOL Mobile Mail
</div>

</div>
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to