This is very, very cool, Mark. I've been concerned for a long time that people take way too seriously what you properly call "bogo-ADEV" that's self-generated from the GPSDO. Integrating a counter that compares against an external source is a huge win.

But I want to remind everyone that as neat as the TICC is, like any time interval counter it still has limited performance for short-term ADEV. The ADEV floor is typically a bit under 1x10e-10 at one second, and goes down at a slope of -1 (so, a bit under 1x10e-13 at 1000 seconds averaging).

If you're comparing a pair of decent sources, results at measurement tau of less than at least several hundred seconds are likely showing counter jitter, not real performance. It's important always to keep that in mind.

John
----

On 02/23/2017 05:27 PM, Mark Sims wrote:
I just added the capability of Heather to monitor and control a GPS device while 
simultaneously calculating ADEVs from an external time interval counter like the TAPR 
TICC  (it can also work with the time interval analyzer only).  This mode lets Heather 
calculate true adevs instead of "bogo-adevs" derived from the GPSDO 
self-reported control loop statistics.

As a test.  I connected Heather to a Trimble "UUCM" GPSDO and a TICC.  The TICC 
channel A is the UCCM and channel B is a Oscilloquartz Star-4 GPSDO.  The TICC reference is 
a ERC-130 rubidium (uses an LPRO-101.  Attached is a screen dump of a 12 hour run.  The UUCM 
beats the Star-4 at tau<20 seconds.

There are a few variants of the UCCM receivers out there... one by Symmetricom and at least two (UCCM and UCCM-P) by 
Trimble.  They run off of 6VDC.   Performance is not too shabby for a small $70-$120 GPSDO.   Search Ebay for 
"Trimble 65256",  "Trimble GPSDO", or "Symmetricom GPSDO".   Be aware that there are 
sellers sending units that were damaged in salvage.   I'd probably go with a "tested" unit.



_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to