OK, but how does the phase noise of the GPSDO make the ADEV for the Cs worse
than that for the GPSDO? I find it hard to believe that the phase noise from
two separate units would cancel out for two GPSDOs but add for the Cs.
Bob
From: Bruce Griffiths <bruce.griffi...@xtra.co.nz>
To: Bob Stewart <b...@evoria.net>; Discussion of precise time and frequency
measurement <time-nuts@febo.com>
Sent: Saturday, March 4, 2017 6:03 PM
Subject: Re: [time-nuts] Cs standard stability
BobWe are certainly not off track.The phase noise of the GPSDO affects the
trigger jitter of both the 5370A and the jitter of the GPSDO PPS output and
consequently the ADEV measured by your setup. NB ADEV depends on the
measurement bandwidth which is relatively small when using a Timepod. Bruce
On 05 March 2017 at 12:31 Bob Stewart <b...@evoria.net> wrote:
Bruce,
Are we getting a bit off track? The question I asked is in regards to the Cs,
not the purity of the output of the GPSDO. The two ADEVs were done under the
same conditions, yet the ADEV of the Cs is obviously not as good as that of the
GPSDO. Also, the ADEV of the GPSDO pretty much tracks what is to be expected
when run on a good 5370, isn't it?
Bob
From: Bruce Griffiths <bruce.griffi...@xtra.co.nz>
To: Bob Stewart <b...@evoria.net>; Discussion of precise time and frequency
measurement <time-nuts@febo.com>
Sent: Saturday, March 4, 2017 5:22 PM
Subject: Re: [time-nuts] Cs standard stability
BobThe Phase noise of that GPDSO seems quite high and some form of filtering
(bandpass or low pass) of its output may be necessary to reduce the resultant
jitter when connected to the 5370A input.There are commercial TDCs that claim
that sort of performance (~10ps) but a comprehensive test of their actual
performance appears as yet unavailable.HP used to sell a TDC with 5ps
resolution but detailed specs are unavailable.Higher resolution and lower noise
should be achievable but would require a lot of number crunching for each
measurement. Bruce
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
