On 5/6/2017 8:13 PM, ziggy9+time-n...@pumpkinbrook.com wrote:
A few notes on the GPSDO module:
- the 5 pin header near U19, the LM74 temp sensor:
- pin 5 or the third pin in the row closest to U19 is the 12v input
(measured). the other 4 are all ground.
- the 15 pin header:
- pins 1,2,5,6,9,10,13,14 are all ground
- pins 3 and 4 are 3.3v ttl level, I’m guessing another serial port
- pins 7 and 8 are 3.3v ttl level, and contain the same data as J2 pin 2
- pins 11,12 are 1 pps, 10ms, 5v
Hi Paul and list,
When you say "pins 3 and 4 are 3.3v ttl level, and contain the same data
as J2 pin 2" does that mean that pins 7 and 8 on on the 15 pin header
are the RX/TX pair TTL side of the SIPEX TTL-to-RS232 chip?
+
One of the things I was hoping for was to find TTL access to the serial
port so I don't have to go Arduino TTL to RS232 off-board and then go
back from RS232 with the Sipex chip on the board.
Have taken a look-see on pins 3 and 4 to see if there is any serial data
coming in / going out of there?
thanks much,
ben
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
