[email protected] said:
> I'm wondering if something like this $10 item
> http://www.nulsom.com/datasheet/NS-RS232_en.pdf 

That setup has a separate pin (hole?) for power.  It's setup to expect Gnd, 
Tx, Rx, and Pwr from the TTL side.

A previous message said the module designed for the job had a diode.  I'd 
expect that is using power from one of the modem control signals.

You could probably add a diode to make it work.


> I don't know if I've seen an inverting one and that would seem a more costly
> approach than handling the inversion on the clock board. 

Almost all TTL to RS-232 level shifter chips include an inverter.  It's just 
historical.  The first chips (MC1488, MC1489) did it that way and everybody 
who makes a new chip includes the inverter too so they can cleanly replace 
older chips.


-- 
These are my opinions.  I hate spam.



_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to