[Correcting my earlier comment.]
> You could probably add a diode to make it work.

It takes more than just a diode.

The voltage on the modem control signals is probably too high.  You will also 
need some way to drop it to what the chip expects, probably 5 volts.  Simple 
3 pin regulators need input and output caps.  There is probably one already 
on the output side.

The just-a-diode from a message early in this thread works because the LM358 
op-amp can take a higher supply voltage.


-- 
These are my opinions.  I hate spam.



_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to