> Unfortunately the unit that you have does not allow for a fw update. Oh well it was worth asking.
Dave -----Original Message----- From: time-nuts [mailto:[email protected]] On Behalf Of Bob kb8tq Sent: 31 July 2017 17:30 To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] Trimble Thunderbolt no longer determines the correct date Hi Trimble, even on supported products, is pretty firm about a service contract being in place for updates. The only exception seems to be security related patches. There have been a lot of examples of this over the years ….AFIK, there isn’t even a “public” firmware loader for the TBolt. Indeed, you might get lucky. Bob > On Jul 31, 2017, at 5:27 AM, David C. Partridge > <[email protected]> wrote: > > I emailed Trimble on the off chance they might have a firmware upgrade. They > sent me an email which covered some units that rolled over in Feb. 2016 for > which they say they have no upgrade. > > I sent them all the information on the label stuck to the outside of my TB > (one of the group buy set), to see if there's any hope ... > > I'm not optimistic, but if you don't ask, you don't get. > > Cheers > Dave > > -----Original Message----- > From: time-nuts [mailto:[email protected]] On Behalf Of Mark > Sims > Sent: 30 July 2017 17:18 > To: [email protected] > Subject: [time-nuts] Trimble Thunderbolt no longer determines the > correct date > > That does not appear to be the case. If it did a reset the DAC should have > gone to the InitV eeprom setting of 2.800V, but instead mine spiked to > 0.308V which is not close to the InitV or the last known DAC values. > > My log file shows the unit did a filter-reinit followed two seconds later by > phase locking the PPS. > > -------------- > >> Or maybe the TBolt reset on rollover and went back to a previously saved DAC >> value. > _______________________________________________ > time-nuts mailing list -- [email protected] To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
