I've been trying to get LH (V5) to control and set position for the GPS
board in one of my GPSDOs. It is a Trimble "Lassen Ace III" Rx
according to itself. LH auto detects it quickly enough, reports it as a
TSIP receiver but then shows a screen saying "LOG: OFF", a blank graph
grid and nothing much else. No data apparently, so how did it autodetect?
I've been beating my head against this for two days; it used to work
fine but since a tantalum went on the TTL to RS232 convertor (since
replaced along with the receiver itself just in case) it won't perform
for me. LH performs fine for all the other units here as it always has
and the Trimble Monitor program works on this one.
I'd really appreciate someone telling me gently what stupid thing I'm
doing or not doing :^)
Thanks,
Dan - ac6ao
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
