Hi Yes, there is what appears to be a socketed ROM on the board. Next step seems to be to dump the ROM and see what’s inside.
Bob > On Apr 9, 2018, at 3:55 PM, Forrest Christian (List Account) > <li...@packetflux.com> wrote: > > Just curious, is there by chance a removable eprom or other programmable > device on these boards? > > Assuming a fairly verbose scpi like command interface, I've occasionally > had luck reverse engineering a command set by looking through an eprom dump > for a list of commands? > > Also, does this by chance respond to the standard scpi commands like *IDN? > and *TST? > > On Mon, Apr 9, 2018, 12:24 PM Bill <br...@otelco.net> wrote: > >> I have two of these with 488 interfaces. >> Would appreciate any 488 info you get. >> br...@otelco.net >> >> -----Original Message----- >> From: Bob kb8tq >> Sent: Saturday, April 07, 2018 10:27 PM >> To: lee...@aol.com ; Discussion of precise time and frequency measurement >> Subject: Re: [time-nuts] Looking for IEEE-488 codes and formats for Datum >> 9700AT Programmable Time System >> >> Hi >> >> Actually the manual is moot on any sort of remote control. The RS-232 >> section refers you to an insert >> in the back of the manual. I’d guess that the 488 stuff was done the same >> way. >> >> Nasty question: Are you sure you have the 488 option installed? It would >> not be the first piece of gear >> produced that never really got a 488 firmware version ….. >> >> Bob >> >>> On Apr 7, 2018, at 11:11 PM, Tom Leedy via time-nuts <time-nuts@febo.com >>> >>> wrote: >>> >>> >>> Hi: >>> >>> I am looking for the IEEE-488 codes and formats for a Datum 9700AT >>> Programmable Time System. The 9700AT is a 1U time generator and >>> translator with slots in the back that can accept option cards with >>> various functionalities such as -488 and RS-232 interfaces, GPIO, and >> tape >>> searches. What I need is the character strings to output the time for >>> the -488 interface. The manual for the unit is here: >>> >> http://www1.symmetricom.com/media/files/support/ttm/product-manual/man-9700at-9710.pdf >>> However, it is silent on the details of the -488 interface. >>> >>> Any help would be appreciated and feel free to contact me offline. >>> >>> Many thanks! >>> >>> Tom Leedy >>> Clarksburg, MD >>> >>> >>> _______________________________________________ >>> time-nuts mailing list -- time-nuts@febo.com >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> >> >> --- >> This email has been checked for viruses by Avast antivirus software. >> https://www.avast.com/antivirus >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.