Thanks Donald. I'm confused as to why my previous 10/8 range would not work in this case?
Surely I'm just asking tinc for a huge address range but only using two addresses, (similar to your example), yet mine does not work. Sent from my iPhone On 03/05/2013, at 1:49 AM, Donald Pearson <[email protected]> wrote: As an example, one of the setups I ran was 2 sites, reach with a local /24. Tinc subnets were configured on each side with a /25 inside of the local /24. Any devices that you would wish to participate in the VPN, you'd provision with an IP inside of the /25. Otherwise provision it inside of the /24. The devices themselves would still use a /24 mask but the VPN would only expose half of that range due to it's /25 configuration. In that way for any one site, all local devices could communicate with all other local devices, and 1/2 of the IP range of the remote site through the VPN. On Thu, May 2, 2013 at 11:04 AM, Guus Sliepen <[email protected]> wrote: > On Fri, May 03, 2013 at 12:51:34AM +1000, Andrew Armstrong wrote: > > > Thanks Guus, I will try this shortly. Can you elaborate on when an actual > > subnet of (say) 10.0.0.0/8 would ever be used (or things other than a > /32 > > address). > > You typically use things other than a /32 when you have a LAN connected to > a > node running tinc, and you want to make the whole LAN part of the VPN. > > See for example the configuration described in the manual: > > http://tinc-vpn.org/documentation/tinc_4.html#Example-configuration > > -- > Met vriendelijke groet / with kind regards, > Guus Sliepen <[email protected]> > > _______________________________________________ > tinc mailing list > [email protected] > http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc > > _______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
_______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
