On Jul 7, 2008, at 12:45 PM, Tahir Azim wrote: > Hi, > > I am trying to get the light sensor of an MTS300 sensorboard (I > think its CB as it has the green wire at the back) to work with a > micaZ mote. I started from the tinyos 2.0.0 release code, but > couldnt get it to work. So I copied over the tos/sensorboards/mts300/ > * files from the tinyos 2.0.2 release and then made the following > changes: > > * Changed MicaBusC.nc by adding the Int0,1,2,3 pins and wiring them > to HplAtm128GeneralIOC.PortE4,5,6,7 respectively. > * Replaced ResourceDefaultOwner with ResourceController in > PhotoTempDeviceC.nc > > This enabled me to compile the code and get it running on the micaz > with the PhotoC sensor wired into my app. But simply wiring in the > PhotoC sensor (and not even calling 'read' on it) causes the radio > to stop working. I've also tried changing > > TempControl.Power -> MicaBusC.Int2; > > in PhotoTempDeviceC.nc to > > TempControl.Power -> MicaBusC.PW0 > > as per a previous email on this list, but that doesnt enable the > radio to work either. > > Is there some way I can still get the light sensor and the radio to > work in this configuration? Or must I update my entire tinyos tree > to 2.0.2?
Can you define "causes the radio to stop working?" Phil _______________________________________________ Tinyos-help mailing list Tinyos-help@millennium.berkeley.edu https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help