You should contact Crossbow; they are very good about fixing dead motes. -Joe
On Mon, 14 Feb 2005 17:12:00 +0100, Christian Fl�gel <[EMAIL PROTECTED]> wrote: > We have three Mica2dots which do not work anymore. Two of them are not > even discoverable (uisp cannot detect them) and usip supplies the > following error: > > An error has occurred during the AVR initialization. > * Target status: > Vendor Code = 0xff, Part Family = 0xff, Part Number = 0xff > > Probably the wiring is incorrect or target might be `damaged'. > make: *** [program] Error 2 > > One doesn't seem to be in the reset state: > > Probably the AVR MCU is not in the RESET state. > Check it out and run me again. > make: *** [program] Error 2 > > AVRStudio 4 will not detect either one of those motes (testet with a JTAG > Ice) > > Note that I use the serial programming board mib510 and NOT the parallel > port board. > > Is there any way to detect why these motes do not respond or do I have to > send them in? How could one revive those motes? > > Christian > > > _______________________________________________ > Tinyos-users mailing list > [email protected] > http://mail.Millennium.Berkeley.EDU/mailman/listinfo/tinyos-users > > > > _______________________________________________ Tinyos-users mailing list [email protected] http://mail.Millennium.Berkeley.EDU/mailman/listinfo/tinyos-users
