Mycenius wrote: > FWIW I'd be a bit concerned if you have that many active devices on the > single Wi-Fi - mesh or no mesh - basically if even ΒΌ are all doing stuff > at the same time there will not be much bandwidth per device... Again > FWIW if it was me I'd be running 2 WLANs (2.4GHz) at opposite ends of > the channel ranges (e.g. something like 3, and 9 or 11), and use one for > your mesh for all your other devices and have one dedicated to only your > SBT and nothing else. (Note: If your router and WAPs support up to > Channel 13, you can use 11, if not it's about 9 - if you are in the USA > it will only be up to 11 I think. You should ideally only use something > like 3, 6 or 9 IIRC, due to overlap - if you have lots of neighbours > around any of these then avoid and use the other one(s) if possible). > > You probably need to just get a long Ethernet cable and run it to the > SBT (or move everything to where you router is) and just try that for a > bit - to eliminate the WI-Fi entirely from the equation.
Thanks. I dont know if its possible to run 2 WLAN's I would have to get someone to run a cable from my router(basement) to SBT (1st floor) Do you think I might get better results if I was able to connect the SBT to the Orbi satellite via ethernet? Or since the satellite is wireless it won't matter much? ------------------------------------------------------------------------ gellie's Profile: http://forums.slimdevices.com/member.php?userid=34468 View this thread: http://forums.slimdevices.com/showthread.php?t=111529
_______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
