Dear Mike, in message <[EMAIL PROTECTED]> you wrote: > > There were differences in the PHY setup between Linux and U-Boot. > > This patch fixes the problem. Apparently "remote fault" is being set, > which signals to some devices (on the other end of the cable) that a > fault has occurred, while other devices ignore it. I believe the RF bit > was causing the issue, but I removed T4 also, to match up with Linux.
Excellent! thanks a lot. Stefan, can you please test this tomorrow morning in the VL setup? If possible, I would like to see this go into the 1.3.2 release. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] When choosing between two evils, I always like to take the one I've never tried before. -- Mae West, "Klondike Annie" ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
