In message <[EMAIL PROTECTED]> you wrote: > > There were differences in the PHY setup between Linux and U-Boot. > > This patch fixes the problem. Apparently "remote fault" is being set, > which signals to some devices (on the other end of the cable) that a > fault has occurred, while other devices ignore it. I believe the RF bit > was causing the issue, but I removed T4 also, to match up with Linux.
I verified that it fixes the problem with our setup (Sequoia board with HP Procurve switch), too. I still see a timeout for the very first packet after a reset, but after that it's working fine. Thanks. Could you just please add your Signed-off-by: line? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] At the source of every error which is blamed on the computer you will find at least two human errors, including the error of blaming it on the computer. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
