In message <[EMAIL PROTECTED]> you wrote: > > When I enter the "target remote" command, it ends up in 0x00000000 instead > of the reset vector at 0xfffffffc. I have pasted my commands below. Can > anyone tell me what I'm missing? I just want to step through a few > instructions and verify that the reset vector code jumps to _start (or > _start_440 in my case), and then step through _start afterwards.
Probably your BDI config file needs adjusting. Try what you see when you use the telnet interface directly, i. e. where do you end up after a "reset halt" ? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] "...one of the main causes of the fall of the Roman Empire was that, lacking zero, they had no way to indicate successful termination of their C programs." - Robert Firth ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users
