Hi everyone, I hope everything requiered is there this time:
* The SKU ID has been changed to SKU_ID_T30MQS_P_A3 as suggested by Thierry * A new patch has been added to enable the 5th i2c bus on T30, this is now needed because: * The i2c buses have been re-numbered to match the numbering used in the kernel * The DTS has been re-worked to better reflect the split between COM and base board. For the i2c buses the split was done according to where the pull-ups are. So buses enabled in the COM dts have their pull-ups on the COM module. * All the "useless" defines have now been removed. Alban Bedel (3): ARM: tegra: support SKU b1 of Tegra30 i2c: tegra: Add the fifth bus on SoC with more than 4 buses ARM: tegra: Add the Tamonten™ NG Evaluation Carrier board arch/arm/cpu/tegra-common/ap.c | 1 + arch/arm/include/asm/arch-tegra/tegra.h | 1 + .../common/pinmux-config-tamonten-ng.h | 385 +++++++++++++++++++++ board/avionic-design/common/tamonten-ng.c | 85 +++++ board/avionic-design/dts/tegra30-tamonten.dtsi | 69 ++++ board/avionic-design/dts/tegra30-tec-ng.dts | 18 + board/avionic-design/tec-ng/Makefile | 32 ++ boards.cfg | 1 + drivers/i2c/tegra_i2c.c | 5 + include/configs/tec-ng.h | 84 +++++ 10 files changed, 681 insertions(+) create mode 100644 board/avionic-design/common/pinmux-config-tamonten-ng.h create mode 100644 board/avionic-design/common/tamonten-ng.c create mode 100644 board/avionic-design/dts/tegra30-tamonten.dtsi create mode 100644 board/avionic-design/dts/tegra30-tec-ng.dts create mode 100644 board/avionic-design/tec-ng/Makefile create mode 100644 include/configs/tec-ng.h -- 1.8.4.2 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
