> > This patch series depends on the following patch: > > > > [U-Boot,v4,03/10] ARM: non-sec: reset CNTVOFF to zero > > > > Before switching to non-secure, make sure that CNTVOFF is set > > to zero on all CPUs. Otherwise, kernel running in non-secure > > without HYP enabled (hence using virtual timers) may observe > > But we have HYP enabled. In this case why are the series dependent on > this patch? >
Well, if the HYP is enabled, the host OS will use the Physical timer, and these CNTVOFFs could be cleared in kernel too. When and where to clear them is better ? In uboot or in kernel when needed? Thanks, BRs Xiubo > > timers that are not synchronized, effectively seeing time > > going backward... > > > > > > > > Patch work: > > http://patchwork.ozlabs.org/patch/343084/ > > > > > > > > > > > > Xiubo Li (4): > > ARM: fix the ARCH Timer frequency setting. > > ARM: add the pen address byte reverting support. > > ARM: LS1021A: enable ARMv7 virt support for LS1021A A7 > > ARM: LS1021A: to allow non-secure R/W access for all devices' mapped > > region > > > > arch/arm/cpu/armv7/ls102xa/cpu.c | 12 +++ > > arch/arm/cpu/armv7/nonsec_virt.S | 7 +- > > arch/arm/include/asm/arch-ls102xa/immap_ls102xa.h | 98 +++++++++++++++++- > - > > board/freescale/ls1021aqds/ls1021aqds.c | 110 > +++++++++++++++++++-- > > board/freescale/ls1021atwr/ls1021atwr.c | 111 > ++++++++++++++++++++-- > > include/configs/ls1021aqds.h | 9 ++ > > include/configs/ls1021atwr.h | 9 ++ > > 7 files changed, 333 insertions(+), 23 deletions(-) > > Diana _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
