[U-Boot] [PATCH 09/20] tegra: spi: Support slow SPI rates

[Simon Glass]

Use the oscillator as the source clock when we cannot achieve a low-enough
speed with the peripheral clock. This happens when we request 3MHz on a SPI
clock, for example.

Signed-off-by: Simon Glass <s...@chromium.org>
---

 drivers/spi/tegra114_spi.c | 18 +++++++++++++++---
 1 file changed, 15 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/tegra114_spi.c b/drivers/spi/tegra114_spi.c
index a73c6b0..1c5368b 100644
--- a/drivers/spi/tegra114_spi.c
+++ b/drivers/spi/tegra114_spi.c
@@ -143,6 +143,7 @@ static int tegra114_spi_probe(struct udevice *bus)
 {
        struct tegra_spi_platdata *plat = dev_get_platdata(bus);
        struct tegra114_spi_priv *priv = dev_get_priv(bus);
+       ulong rate;
 
        priv->regs = (struct spi_regs *)plat->base;
 
@@ -150,9 +151,20 @@ static int tegra114_spi_probe(struct udevice *bus)
        priv->freq = plat->frequency;
        priv->periph_id = plat->periph_id;
 
-       /* Change SPI clock to correct frequency, PLLP_OUT0 source */
-       clock_start_periph_pll(priv->periph_id, CLOCK_ID_PERIPH,
-                              priv->freq);
+       /*
+        * Change SPI clock to correct frequency, PLLP_OUT0 source, falling
+        * back to the oscillator if that is too fast.
+        */
+       rate = clock_start_periph_pll(priv->periph_id, CLOCK_ID_PERIPH,
+                                     priv->freq);
+       if (rate > priv->freq + 100000) {
+               rate = clock_start_periph_pll(priv->periph_id, CLOCK_ID_OSC,
+                                             priv->freq);
+               if (rate != priv->freq) {
+                       printf("Warning: SPI '%s' requested clock %u, actual 
clock %lu\n",
+                              bus->name, priv->freq, rate);
+               }
+       }
 
        setbits_le32(&priv->regs->command1, SPI_CMD1_M_S | SPI_CMD1_CS_SW_HW |
                     (priv->mode << SPI_CMD1_MODE_SHIFT) | SPI_CMD1_CS_SW_VAL);
-- 
2.2.0.rc0.207.ga3a616c

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot