Hi Joe, On Wed, 2016-01-13 at 16:59 +0300, Alexey Brodkin wrote: > In some cases Ethernet PHY and network itself might support speeds > which are not supported by Ethernet controller (MAC). > > To support that kind of situation it is required to force limit > PHY so it is not configured for unsupported mode or even if PHY > autonegotiated too high speed it will be reconfigured for slower mode. > > Note this series is v2 because v1 patches were sent separately not being > aranged in series. And now I'm putting all patches in one series > and marking it v2 even though no changes were done in patches itself. > > Alexey Brodkin (4): > drivers/net/phy: introduce phy_set_supported() > include/net.h: add max_speed member in struct eth_pdata > net/designware: do explicit port selection for 1Gb mode > net/designware: add support of max-speed device tree property > > Florian Fainelli (2): > net: phy: ensure Gigabit features are masked off if requested > net: phy: breakdown PHY_*_FEATURES defines > > Sascha Hauer (1): > net: phy: genphy: Allow overwriting features > > drivers/net/designware.c | 16 +++++++++- > drivers/net/designware.h | 1 + > drivers/net/phy/phy.c | 77 > ++++++++++++++++++++++++++++++++++-------------- > include/net.h | 2 ++ > include/phy.h | 23 ++++++++++----- > 5 files changed, 89 insertions(+), 30 deletions(-)
Please treat this as a polite reminder to review that series sometime soon. -Alexey _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot