Hi Stefano, On Wed, Oct 5, 2016 at 2:17 AM, Jagan Teki <jt...@openedev.com> wrote: > From: Jagan Teki <ja...@amarulasolutions.com> > > This series supports Engicam i.CoreM6 QDL modules on top of u-boot-imx/master > and test on the respective starter kits as well. > > Tested both MMC and NAND boot. > > Changes for v6: > - Rebase to u-boot-imx/master > - Move few SPL configs to defconfigs > > Changes for v5: > - Add NAND support > > Changes for v4: > - Add 'net: Kconfig: Add FEC_MXC entry' patch > - Updated ENV configs along with comments > - Restructured configs for more readability > - Add CONFIG_ENV_OVERWRITE > - Rename icorem6qdl_defconfig with icorem6qdl_mmc_defconfig > > Changes for v3: > - Remove "v2 01/17 imx: iomux-v3: Fix build error with snvs base" > patch > - Remove 'default n' on Kconfig DEFAULT_FDT_FILE patch > - Add minimal devicetree support for Engicam i.CoreM6 QDL > - Add is_mx6dl() > - Add is_mx6solo() > - Use is_mx6dq() > - Add last commit sha1 and header in pull devicetree files from Linux > > Changes for v2: > - Make static to local iomux structure in board file > - Corrected rowaddr in mx6_ddr3_cfg > - Used imx_ddr_size > - Add FEC support and tested the same > - Add DM_GPIO, DM_MMC support > - Add pinctrl support > - Add devicetree support > > Jagan Teki (21): > serial: Kconfig: Add MXC_UART entry > thermal: Kconfig: Add IMX_THERMAL entry > Kconfig: Add DEFAULT_FDT_FILE entry > arm: imx: Add Engicam i.CoreM6 QDL Starter Kit initial support > net: Kconfig: Add FEC_MXC entry > imx6: icorem6: Add ENET support > imx: s/docs\/README.imximage/doc\/README.imximage/g > arm: dts: Add devicetree for i.MX6DL > arm: dts: Add devicetree for i.MX6DQL > arm: dts: imx6dl: Add pinctrl defines > dt-bindings: clock: imx6qdl: Add clock defines > arm: imx6q: Add devicetree support for Engicam i.CoreM6 DualLite/Solo > imx6q: icorem6: Enable pinctrl driver > engicam: icorem6: Add DM_GPIO, DM_MMC support > arm: dts: Add devicetree for i.MX6Q > arm: dts: imx6q: Add pinctrl defines > arm: imx6q: Add devicetree support for Engicam i.CoreM6 Quad/Dual > mtd: nand: Kconfig: Add NAND_MXS entry > imx6: icorem6: Add NAND support > imx6: icorem6: Enable MTD device support > imx6: icorem6: Add default mtd nand partition table
All look fine on u-boot-imx/master, please apply thanks! -- Jagan Teki Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream Maintainer Hyderabad, India. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
