On Tue, 16 Mar 2010 08:30 -0400, Henry Súcart wrote : > Here's the command I'm using and the output. I put a debugging statement in > sd_init_card() after the for loop (HJS:). > > U-Boot> mmc init 0 > mmc: clock 150000 too low; setting CLKDIV to 255 > HJS: sd_init_card() mmc_acmd for loop finished. ret = -19, resp[0] = > 0x6B200020 > No MMC card found
Err, well, that's weird. I have to admit I can't even guess whether it's trying to read the right slot. Could you please: 1/ add a #define DEBUG at the top of drivers/mmc/atmel_mci.c 2/ get the output of mmc init (0 or 1 doesn't matter) for both CONFIG_ATMEL_MCI1 and !CONFIG_ATMEL_MCI1 (with the SD card staying in the same slot, of course) 3/ In the process, add a debug printf in the mci driver displaying the value of MMCI_CR (you'd get that by calling mmci_readl(CR)) I'm sorry I can't help you further. Unfortunately I don't own such hardware, and this kind of thing is rather hard to debug remotely. Regards, -- Albin Tonnerre, Free Electrons Kernel, drivers and embedded Linux development, consulting, training and support. http://free-electrons.com _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot