Dear Tom, I am still waiting for Ack/feedback if any on this patchset v3 All feedbacks provided by you on patchset v2 have been incorporated
Regards Vipin On 5/9/2010 7:46 PM, Vipin Kumar wrote: > Hello Tom, > > Please consider this patch-set for mainline submission. > Please let me know if there are any changes to be made > in code or if the patches are good to go into mainline > > Thanks & Regards > Vipin > > On Thu, May 6, 2010 at 4:48 PM, Vipin KUMAR <vipin.ku...@st.com> wrote: >> Hello Tom, >> The following patch-set contains all the accepted feedbacks on patch-set >> v2. >> Please consider this for submission into mainline >> >> Below changes are introduced other than the recieved review comments >> 1. Introduced a CONFIG_DW_SEARCH_PHY definition, which if defined searches >> the ethernet phy address. Searching was always enabled in earlier patch >> 2. Introduced a new function dw_write_hwaddr in ethernet driver and >> registered it as a callback via dev->write_hwaddr. This is a new feature >> recently implemented by Ben. >> >> Thanks in advance >> >> Regards >> Vipin >> >> Vipin Kumar (19): >> u-boot.img file not created when srctree and objtree are different >> change_bit routine defined >> SPEAr : SMI erase and write timeouts increased >> SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET >> SPEAr : Reducing the max RAM size to 128MB >> SPEAr : Basic arch related support added for SPEAr SoCs >> SPEAr : Network driver support added >> SPEAr : Network support configured for spear SoCs >> SPEAr : macb driver support added for spear310 and spear320 >> SPEAr : FSMC driver support added >> SPEAr : Configuring FSMC driver for NAND interface >> SPEAr : i2c driver moved completely into drivers/i2c >> SPEAr : smi driver moved completely into drivers/mtd >> SPEAr : USB Device Controller driver support added >> SPEAr : Supporting various configurations for spear3xx and spear6xx >> boards >> SPEAr : Basic spear1300 architecture support added >> SPEAr : spear1300 SoC support added >> SPEAr : Removing extraneous code >> SPEAr : USB device controller bugfixes >> >> MAINTAINERS | 1 + >> MAKEALL | 1 + >> Makefile | 30 +- >> arch/arm/cpu/arm926ejs/spear/Makefile | 3 +- >> arch/arm/cpu/arm926ejs/spear/cpu.c | 78 +++ >> arch/arm/cpu/arm_cortexa8/spear13xx/Makefile | 52 ++ >> arch/arm/cpu/arm_cortexa8/spear13xx/cache.S | 114 +++++ >> arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c | 96 ++++ >> .../arm_cortexa8/spear13xx/reset.c} | 52 +-- >> arch/arm/cpu/arm_cortexa8/spear13xx/timer.c | 138 +++++ >> .../arm/include/asm/arch-spear/clk.h | 26 +- >> arch/arm/include/asm/arch-spear/hardware.h | 16 +- >> arch/arm/include/asm/arch-spear/spr_misc.h | 5 + >> .../arm/include/asm/arch-spear13xx/hardware.h | 33 +- >> arch/arm/include/asm/arch-spear13xx/spr_gpt.h | 85 ++++ >> arch/arm/include/asm/arch-spear13xx/spr_misc.h | 317 ++++++++++++ >> .../arm/include/asm/arch-spear13xx/sys_proto.h | 29 +- >> arch/arm/include/asm/bitops.h | 11 +- >> board/spear/common/Makefile | 10 +- >> board/spear/common/spr_misc.c | 28 +- >> board/spear/spear1300/Makefile | 51 ++ >> board/spear/spear1300/config.mk | 28 + >> board/spear/spear1300/spear1300.c | 88 ++++ >> .../spear/spear1300/spr_lowlevel_init.S | 35 +- >> board/spear/spear300/config.mk | 11 - >> board/spear/spear300/spear300.c | 15 +- >> board/spear/spear310/config.mk | 11 - >> board/spear/spear310/spear310.c | 36 ++- >> board/spear/spear320/config.mk | 11 - >> board/spear/spear320/spear320.c | 23 +- >> board/spear/spear600/config.mk | 11 - >> board/spear/spear600/spear600.c | 15 +- >> doc/README.designware_eth | 25 + >> doc/README.spear | 46 ++- >> drivers/i2c/Makefile | 2 +- >> drivers/i2c/{spr_i2c.c => designware_i2c.c} | 4 +- >> .../spr_i2c.h => drivers/i2c/designware_i2c.h | 6 +- >> drivers/mtd/Makefile | 2 +- >> drivers/mtd/nand/Makefile | 2 +- >> drivers/mtd/nand/fsmc_nand.c | 366 ++++++++++++++ >> drivers/mtd/nand/spr_nand.c | 124 ----- >> drivers/mtd/{spr_smi.c => st_smi.c} | 59 ++- >> .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h | 8 +- >> drivers/net/Makefile | 1 + >> drivers/net/designware.c | 531 >> ++++++++++++++++++++ >> drivers/net/designware.h | 264 ++++++++++ >> drivers/serial/usbtty.h | 4 +- >> drivers/usb/gadget/Makefile | 2 +- >> drivers/usb/gadget/{spr_udc.c => designware_udc.c} | 116 +++-- >> include/configs/spear-common.h | 33 +- >> include/configs/spear13xx_evb.h | 202 ++++++++ >> include/configs/{spear3xx.h => spear3xx_evb.h} | 30 ++ >> include/configs/{spear6xx.h => spear6xx_evb.h} | 13 + >> include/linux/mtd/fsmc_nand.h | 104 ++++ >> include/netdev.h | 1 + >> include/usb/{spr_udc.h => designware_udc.h} | 6 +- >> 56 files changed, 2993 insertions(+), 418 deletions(-) >> create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c >> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile >> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S >> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c >> rename arch/arm/{include/asm/arch-spear/spr_nand.h => >> cpu/arm_cortexa8/spear13xx/reset.c} (50%) >> mode change 100644 => 100755 >> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c >> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h >> (64%) >> copy include/configs/spear6xx.h => >> arch/arm/include/asm/arch-spear13xx/hardware.h (58%) >> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h >> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h >> copy include/configs/spear6xx.h => >> arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%) >> create mode 100644 board/spear/spear1300/Makefile >> create mode 100644 board/spear/spear1300/config.mk >> create mode 100644 board/spear/spear1300/spear1300.c >> copy include/configs/spear6xx.h => >> board/spear/spear1300/spr_lowlevel_init.S (56%) >> create mode 100644 doc/README.designware_eth >> rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%) >> rename arch/arm/include/asm/arch-spear/spr_i2c.h => >> drivers/i2c/designware_i2c.h (98%) >> create mode 100644 drivers/mtd/nand/fsmc_nand.c >> delete mode 100644 drivers/mtd/nand/spr_nand.c >> rename drivers/mtd/{spr_smi.c => st_smi.c} (94%) >> rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h >> (96%) >> create mode 100644 drivers/net/designware.c >> create mode 100644 drivers/net/designware.h >> rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%) >> create mode 100644 include/configs/spear13xx_evb.h >> rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%) >> rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%) >> create mode 100644 include/linux/mtd/fsmc_nand.h >> rename include/usb/{spr_udc.h => designware_udc.h} (98%) >> >> _______________________________________________ >> U-Boot mailing list >> U-Boot@lists.denx.de >> http://lists.denx.de/mailman/listinfo/u-boot >> > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot