On 5/9/19 4:02 PM, Tom Rini wrote: > On Mon, May 06, 2019 at 09:26:04AM -0400, Tom Rini wrote: > >> Hey folks, >> >> I'm attempting, again, to see what we need to do in order to use gcc-8.x >> for U-Boot and ran into, again: >> https://patchwork.ozlabs.org/patch/920329/ which in short is that when >> using -mcpu=xscale gcc-8.x throws an odd error: >> cc1: error: switch -mcpu=xscale conflicts with -march=armv5te switch >> [-Werror] >> >> Now note, U-Boot isn't passing -march= at all, just -mcpu=xscale which >> suggests perhaps something broke in upstream gcc. Looking at the >> kernel, it's not used -mcpu=xscale ever, just -mtune=xscale but that >> leads to different failures (seen here with gcc-7.3): >> CC drivers/usb/gadget/pxa25x_udc.o >> {standard input}: Assembler messages: >> {standard input}:779: Error: selected processor does not support `pld [lr]' >> in ARM mode >> {standard input}:1201: Error: selected processor does not support `pld [r7]' >> in ARM mode >> {standard input}:2519: Error: selected processor does not support `pld [r3]' >> in ARM mode >> {standard input}:2796: Error: selected processor does not support `pld [r3]' >> in ARM mode >> >> So, what should we do about this? Is there still active interest in >> supporting the PXA platforms? Thanks folks! > > ping? Thanks!
Maybe we should just remove it. -- Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot