Hi Tom On Mon, 2019-05-06 at 09:26 -0400, Tom Rini wrote: > Hey folks, > > I'm attempting, again, to see what we need to do in order to use gcc- > 8.x > for U-Boot and ran into, again: > https://patchwork.ozlabs.org/patch/920329/ which in short is that > when > using -mcpu=xscale gcc-8.x throws an odd error: > cc1: error: switch -mcpu=xscale conflicts with -march=armv5te switch > [-Werror] > > Now note, U-Boot isn't passing -march= at all, just -mcpu=xscale > which > suggests perhaps something broke in upstream gcc. Looking at the > kernel, it's not used -mcpu=xscale ever, just -mtune=xscale but that > leads to different failures (seen here with gcc-7.3): > CC drivers/usb/gadget/pxa25x_udc.o > {standard input}: Assembler messages: > {standard input}:779: Error: selected processor does not support `pld > [lr]' in ARM mode > {standard input}:1201: Error: selected processor does not support > `pld [r7]' in ARM mode > {standard input}:2519: Error: selected processor does not support > `pld [r3]' in ARM mode > {standard input}:2796: Error: selected processor does not support > `pld [r3]' in ARM mode > > So, what should we do about this? Is there still active interest in > supporting the PXA platforms? Thanks folks!
We are actually still shipping Colibri PXA270 modules for another one or two years I believe after which Marvell stops selling us chips. The strange thing is that I build U-Boot master more or less daily without any known issues currently using the regular gcc 8.2 2019.01 tool chain from ARM. The only issue is the missing DM_MMC and/or DM_USB conversion which I started working on a long time ago but never came around properly debugging. I may pick that one up tomorrow again. Cheers Marcel > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > https://lists.denx.de/listinfo/u-boot _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot