On Mon, Sep 23, 2019 at 01:06:35PM +0000, Alexander von Gluck IV wrote: > Ok, looking for differences now.. > > * Older Tinker Board? (I'm not using the Tinker Board S)
yes, the original one > * Same steps? along the lines of gmake CROSS_COMPILE="arm-none-eabi-" tinker-rk3288_defconfig gmake CROSS_COMPILE="arm-none-eabi-" all tools/mkimage -n rk3288 -T rksd -d tpl/u-boot-tpl.bin idbloader.img && \ cat spl/u-boot-spl-dtb.bin >> idbloader.img > * Same config? tinker-rk3288_defconfig? yes > * Uart 115200? yes > * Any HDMI Video output? no hdmi connected only serial > * GCC version? gcc-linaro-6.3.2017.02 binutils 2.27 arm-none-eabi target > > September 23, 2019 12:34 AM, "Jonathan Gray" <j...@jsg.id.au> wrote: > > > On Mon, Sep 23, 2019 at 01:17:40AM +0000, Alexander von Gluck IV wrote: > > > >> Hello! > >> > >> There is no uart output and no video with u-boot master. > >> The board works as expected booting the Asus Armbian image on an SD. > >> > >> At this point i'd be happy to get some u-boot uart output :-) > >> > >> -- Alex > > > > uart output works here with the latest master > > (780a17e814503f71d1b51d578b32bc9c89933183) > > > > U-Boot TPL 2019.10-rc3-00401-ge23a6e5c43 (Sep 23 2019 - 15:13:20) > > Trying to boot from BOOTROM > > Returning to boot ROM... > > > > U-Boot SPL 2019.10-rc3-00401-ge23a6e5c43 (Sep 23 2019 - 15:13:20 +1000) > > Trying to boot from MMC1 > > > > U-Boot 2019.10-rc3-00401-ge23a6e5c43 (Sep 23 2019 - 15:13:20 +1000) > > > > Model: Tinker-RK3288 > > DRAM: 2 GiB > > MMC: dwmmc@ff0c0000: 1 > > Loading Environment from MMC... *** Warning - bad CRC, using default > > environment > > > > In: serial > > Out: serial > > Err: serial > > Model: Tinker-RK3288 > > rockchip_dnl_key_pressed: adc_channel_single_shot fail! > > Net: eth0: ethernet@ff290000 > > Hit any key to stop autoboot: 0 > > switch to partitions #0, OK > > mmc1 is current device > > Scanning mmc 1:1... > > Found EFI removable media binary efi/boot/bootarm.efi > > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > > Scanning disk dw...@ff0c0000.blk... > > Found 3 disks > > BootOrder not defined > > EFI boot manager: Cannot load any image > > 88176 bytes read in 9 ms (9.3 MiB/s) > > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > >>> OpenBSD/armv7 BOOTARM 1.6 > > > > boot> > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > https://lists.denx.de/listinfo/u-boot _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot