Dear Heiko Schocher, [There is no need to always keep the full quote. Please delete parts that are not interesting for the current diuscussion.]
In message <4ca57ce7.1060...@denx.de> you wrote: > > > But one can configure with gaps too, for ex. If any new board uses two > > chips with smaller size then it is possibility of gap insertion. > > > > In that case how it should be? > > Good question ... for this case we must adapt in arch/arm/lib/board.c > > addr = CONFIG_SYS_SDRAM_BASE + gd->ram_size; > > But no idea, where to put u-boot ... at the end of the first > bank? at the end of the last bank? It seems logical to me to put U-Boot to the end of the bank with the highest address. But as mentioned before, this may be not a nice system to use. So far we kind of assume to have a contiguous area of RAM usable. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de If it went on at this rate, in several billion years he'd be rich beyond his wildest dreams! - Terry Pratchett, _Soul Music_ _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot