Jocke, > Andre Schwarz<andre.schw...@matrix-vision.de> wrote on 2010/10/25 15:50:19: > >> Jocke, >> >> [snip] >> >> >>> You still haven't reported weather the 4 nop's helped or not, yet you >>> seek my help. I am just going to ignore you until you do test it. >>> >>> >>> >> finally I got both some time and hardware : >> >> 4 nops after _start does the trick, i.e. the board is up and running fine. >> >> >> Diffing both System.maps and U-Boot hexdump gives only trivial results : >> >> - "in_flash" and "_start_of_vectors" adress increment = 0x10. >> - offset calculation for relative branch instruction also increases by 0x10. >> >> >> Let me know if you need more information or something else tested. >> > I am not looking at this as I am busy but I have an idea or two > ok - thanks. > - CPU bug in 83xx CPUs which uses 0x110 as cold start vector. > This is indeed something FSL has to investigate. But at least *some* 83xx boards are running fine ... e300c2 though. > - Misconfig of HRCW, don't know if you can change the reset vector that way > but I guess you need to check. > HRCW reset vector settings are high/low boot only. > I think a Freescale guy needs to look at this unless you can find something > wrong > with HRCW >
Kim, Timur, can you give any information ? What about your boards ? Is everything running fine using Nor-Boot ? Regards, André MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler Registergericht: Amtsgericht Stuttgart, HRB 271090 Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
