On 30.08.22 14:04, Michael Walle wrote:
Am 2022-08-30 13:53, schrieb Stefan Roese:
Now that the new timer support is available for these platforms, let's
select this IF for all these platforms. This way it's not necessary
that each board changes it's config header.
Signed-off-by: Stefan Roese <s...@denx.de>
---
arch/arm/Kconfig | 4 ++++
arch/arm/mach-mvebu/include/mach/config.h | 5 -----
2 files changed, 4 insertions(+), 5 deletions(-)
diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index 0b72e4f6503e..60f524a2d118 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -618,6 +618,7 @@ config ARCH_KIRKWOOD
select BOARD_EARLY_INIT_F
select CPU_ARM926EJS
select GPIO_EXTRA_HEADER
+ select TIMER
If selected by the arch now (and the timer driver defaulting to
y on this arch), could you clean the lschvl2 and lsxhl_defconfigs up
and remove the two symbols there?
Sure. I can add another patch for this in the next patchset version.
Please complain, if I forget to do this. ;)
Thanks,
Stefan
config ARCH_MVEBU
bool "Marvell MVEBU family (Armada XP/375/38x/3700/7K/8K)"
@@ -629,6 +630,8 @@ config ARCH_MVEBU
select GPIO_EXTRA_HEADER
select SPL_DM_SPI if SPL
select SPL_DM_SPI_FLASH if SPL
+ select SPL_TIMER if SPL
+ select TIMER
select OF_CONTROL
select OF_SEPARATE
select SPI
@@ -639,6 +642,7 @@ config ARCH_ORION5X
select CPU_ARM926EJS
select GPIO_EXTRA_HEADER
select SPL_SEPARATE_BSS if SPL
+ select TIMER
config TARGET_STV0991
bool "Support stv0991"
diff --git a/arch/arm/mach-mvebu/include/mach/config.h
b/arch/arm/mach-mvebu/include/mach/config.h
index 4add0d9e1030..9b5036c31dd3 100644
--- a/arch/arm/mach-mvebu/include/mach/config.h
+++ b/arch/arm/mach-mvebu/include/mach/config.h
@@ -41,9 +41,4 @@
#endif
#endif
-/* Use common timer */
-#define CONFIG_SYS_TIMER_COUNTS_DOWN
-#define CONFIG_SYS_TIMER_COUNTER (MVEBU_TIMER_BASE + 0x14)
-#define CONFIG_SYS_TIMER_RATE 25000000
-
#endif /* __MVEBU_CONFIG_H */
Viele Grüße,
Stefan Roese
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: s...@denx.de
