From: Fabio Estevam <feste...@denx.de> Since commit 1a7904fdfa7d ("mmc: fsl_esdhc_imx: Use esdhc_soc_data flags to set host caps") the following SD card error is observed on an imx7d-sdb board:
U-Boot 2023.04-00652-g487e42f7bc5e (Apr 05 2023 - 22:14:21 -0300) CPU: Freescale i.MX7D rev1.0 1000 MHz (running at 792 MHz) CPU: Commercial temperature grade (0C to 95C) at 35C Reset cause: POR Model: Freescale i.MX7 SabreSD Board Board: i.MX7D SABRESD in non-secure mode DRAM: 1 GiB Core: 100 devices, 19 uclasses, devicetree: separate PMIC: PFUZE3000 DEV_ID=0x30 REV_ID=0x10 MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2 Loading Environment from MMC... Card did not respond to voltage select! : -110 *** Warning - No block device, using default environment Fix the problem by only asserting the UHS_CAPS when supports_uhs() is true instead of doing it unconditionally, only based on the defconfig option. Signed-off-by: Fabio Estevam <feste...@denx.de> --- drivers/mmc/fsl_esdhc_imx.c | 6 +----- 1 file changed, 1 insertion(+), 5 deletions(-) diff --git a/drivers/mmc/fsl_esdhc_imx.c b/drivers/mmc/fsl_esdhc_imx.c index 66caf683f741..bfc94d2a5326 100644 --- a/drivers/mmc/fsl_esdhc_imx.c +++ b/drivers/mmc/fsl_esdhc_imx.c @@ -1258,11 +1258,7 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv, esdhc_write32(®s->tuning_ctrl, val); } - /* - * UHS doesn't have explicit ESDHC flags, so if it's - * not supported, disable it in config. - */ - if (CONFIG_IS_ENABLED(MMC_UHS_SUPPORT)) + if (CONFIG_IS_ENABLED(MMC_UHS_SUPPORT) && supports_uhs(cfg->host_caps)) cfg->host_caps |= UHS_CAPS; if (CONFIG_IS_ENABLED(MMC_HS200_SUPPORT)) { -- 2.34.1