On 4/6/2023 8:14 PM, Fabio Estevam wrote:
From: Fabio Estevam <feste...@denx.de>
Since commit 1a7904fdfa7d ("mmc: fsl_esdhc_imx: Use esdhc_soc_data flags
to set host caps") the following SD card error is observed on an imx7d-sdb
board:
U-Boot 2023.04-00652-g487e42f7bc5e (Apr 05 2023 - 22:14:21 -0300)
CPU: Freescale i.MX7D rev1.0 1000 MHz (running at 792 MHz)
CPU: Commercial temperature grade (0C to 95C) at 35C
Reset cause: POR
Model: Freescale i.MX7 SabreSD Board
Board: i.MX7D SABRESD in non-secure mode
DRAM: 1 GiB
Core: 100 devices, 19 uclasses, devicetree: separate
PMIC: PFUZE3000 DEV_ID=0x30 REV_ID=0x10
MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
Loading Environment from MMC... Card did not respond to voltage select! : -110
*** Warning - No block device, using default environment
Fix the problem by only asserting the UHS_CAPS when supports_uhs() is true
instead of doing it unconditionally, only based on the defconfig option.
Signed-off-by: Fabio Estevam <feste...@denx.de>
---
drivers/mmc/fsl_esdhc_imx.c | 6 +-----
1 file changed, 1 insertion(+), 5 deletions(-)
diff --git a/drivers/mmc/fsl_esdhc_imx.c b/drivers/mmc/fsl_esdhc_imx.c
index 66caf683f741..bfc94d2a5326 100644
--- a/drivers/mmc/fsl_esdhc_imx.c
+++ b/drivers/mmc/fsl_esdhc_imx.c
@@ -1258,11 +1258,7 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv,
esdhc_write32(®s->tuning_ctrl, val);
}
- /*
- * UHS doesn't have explicit ESDHC flags, so if it's
- * not supported, disable it in config.
- */
- if (CONFIG_IS_ENABLED(MMC_UHS_SUPPORT))
+ if (CONFIG_IS_ENABLED(MMC_UHS_SUPPORT) &&
supports_uhs(cfg->host_caps))
cfg->host_caps |= UHS_CAPS;
The supports_uhs is as below, so this condition check will never have
UHS_CAPS set even MMC_UHS_SUPPORT selected. This seems not correct fix.
static inline bool supports_uhs(uint caps)
{
#if CONFIG_IS_ENABLED(MMC_UHS_SUPPORT)
return (caps & UHS_CAPS) ? true : false;
#else
return false;
#endif
}
Regards,
Peng.
if (CONFIG_IS_ENABLED(MMC_HS200_SUPPORT)) {