-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 On 03/08/2011 07:44 AM, Scott Wood wrote: >> +#if defined(CONFIG_QI_LB60) >> > +#define KEY_U_OUT (32 * 2 + 16) >> > +#define KEY_U_IN (32 * 3 + 19) >> > + __gpio_as_input(KEY_U_IN); >> > + __gpio_enable_pull(KEY_U_IN); >> > + __gpio_as_output(KEY_U_OUT); >> > + __gpio_clear_pin(KEY_U_OUT); >> > + >> > + if (__gpio_get_pin(KEY_U_IN) == 0) >> > + usb_boot(); >> > +#endif >> > +#endif > This stuff does not belong in the NAND driver; it belongs under your board > or cpu directory. >
I have tried to move those 'usb_boot' to board files. the only problem is I have to run this 'usb_boot' very early. after CPU load the real u-boot to memory the usb_boot will not working. I will try to found more info about this. then explain more in next email. thanks Scott Wood for your feedback. I will keeping working. until the code is good enough :) - -- Best Regards Xiangfu Liu http://www.openmobilefree.net -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.10 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/ iEYEARECAAYFAk2IWZcACgkQRRAEFRxkgLTVvwCfaw7jKe7ZVzycMS+gN2lFdV2t mEYAoIFahfXxtoiXs565cuN4vAuDdlIR =tdrU -----END PGP SIGNATURE----- _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
