Hi,
On 12/19/23 05:15, Venkatesh Yadav Abbarapu wrote:
This series adds support for Xilinx qspi parallel and stacked memeories.
In parallel mode, the current implementation assumes that a maximum of two
flashes are connected. The QSPI controller splits the data evenly between both
the flashes so, both the flashes that are connected in parallel mode should be
identical.
During each operation SPI-NOR sets 0th bit for CS0 & 1st bit for CS1 in
nor->flags.
In stacked mode the current implementation assumes that a maximum of two
flashes are connected and both the flashes are of same make but can differ in
sizes. So, except the sizes all other flash parameters of both the flashes are
identical.
Spi-nor will pass on the appropriate flash select flag to low level driver, and
it will select pass all the data to that particular flash.
Write operation in parallel mode are performed in page size * 2 chunks as each
write operation results in writing both the flashes. For doubling the address
space each operation is performed at addr/2 flash offset, where addr is the
address specified by the user.
Similarly for read and erase operations it will read from both flashes, so size
and offset are divided by 2 and send to flash.
There are much less errors which is good sign but still
imx28_xea_defconfig shows this.
.../arm-xilinx-linux-gnueabi-ld.bfd.real: drivers/core/ofnode.o: in function
`ofnode_get_property':
/mnt/disk/u-boot/drivers/core/ofnode.c:1185: undefined reference to
`fdt_getprop'
make[1]: *** [scripts/Makefile.spl:527: spl/u-boot-spl] Error 1
And SPL is bigger for taurus_defconfig and axm_defconfig.
And can you please rebase it on the top of next branch?
Thanks,
Michal
