Hi Stefano, On 5/17/2011 9:44 AM, Stefano Babic wrote: > On 05/17/2011 07:06 AM, Jason Liu wrote: >> Hi, Fabio, >> >> 2011/5/17 Fabio Estevam <fabio.este...@freescale.com>: >>> Make the weim register set complete for MX51/MX53. >>> >>> While at it also add the weim chip select 1 address definition. >>> >> >> From the code, you just add the cs for mx53 not for mx51, so, >> Had better specify you add the cs1 address definition for mx53, >> otherwise, it will make confusion. > > Sure ? The structure is not protected by any CONFIG_MX5x switch, and at > least one mx51 board uses it. The registers have the same layout for > both processor. Why do you think is only for MX53 ?
I think what Jason mentions is the fact that I added: #define CS1_BASE_ADDR 0xF4000000 and this was only for MX53 because it is protected by "elif defined(CONFIG_MX53)" I can add the CS1_BASE_ADDR for MX51 as well on my v3 series. The weim layout registers are the same for MX51 and MX53. Regards, Fabi Estevam _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
