On 11/10/25 10:12 AM, Philip Oberfichtner wrote:
[...]
diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 8dade2b501e..97c7bfdad47 100644
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -36,19 +36,33 @@ config SPL_FRAMEWORK_BOARD_INIT_F
- initialize the serial (preloader_console_init)
Unless you want to provide your own board_init_f, you should say Y.
+config HAS_SPL_SIZE_LIMIT
+ bool "Enable size limit check for the SPL image"
+ depends on !COMPILE_TEST
+ depends on SPL
+ default y if ARCH_MX6
+ default y if ARCH_MVEBU && ARMADA_32BIT
+ default y if ARMADA_38X
+ default y if K3_DM_FW
K3_DM_FW is some driver, what you likely want here is:
default y if ARCH_K3 && CPU_V7R && !SOC_K3_AM642 && !SOC_K3_AM654 &&
!CLK_TI_SCI && !TI_SCI_POWER_DOMAIN
But it seems am64x_evm_r5_defconfig below enables HAS_SPL_SIZE_LIMIT too
, so likely remove !SOC_K3_AM642 from the above, which will allow you to
reduce the amount of configs/ file changes.
+ default y if SOC_K3_AM625
+ default y if SOC_MT7621
+ default y if TARGET_SOCFPGA_GEN5
You could also add Xilinx Zynq/ZynqMP into the defaults here, which will
further reduce the configs/ file changes.
The rest looks fine, thanks !
