Dear "Ira W. Snyder", In message <20110714195525.gf19...@ovro.caltech.edu> you wrote: > > It says, right at the top: > > ; The values used to configure the memory controller > ; are the ones U-boot uses to setup my system. > ; Your system may need different ones !!! > ; > ; This configuration is not usable for U-boot debugging. > ; Use it to debug example code loaded into SDRAM.
Correct. For U-Boot debugging, you will normally remove / comment out all such config stuff anyway. Please see the manual. > I'm hoping for a configuration that can program the flash on a bricked > board. Then I can flash anything I want without fear of rendering an > expensive board useless. If your code is really in SPI flash then you need to be able to initialize the RAM and load and start U-Boot theree, because the BDI cannot write SPI flash directly. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Pray: To ask that the laws of the universe be annulled in behalf of a single petitioner confessedly unworthy. - Ambrose Bierce _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot