Dear Shinya Kuribayashi, In message <4e886da5.1010...@pobox.com> you wrote: > From: Xiangfu Liu <xian...@openmobilefree.net> > Date: Fri, 19 Aug 2011 14:35:29 +0800 > > Add support for the qi_lb60 (a.k.a QI Ben NanoNote) clamshell device > from Qi hardware: > > http://en.qi-hardware.com/wiki/Ben_NanoNote > http://en.qi-hardware.com/wiki/Main_Page > http://en.wikipedia.org/wiki/Qi_hardware > > This Jz4740-based clamshell device does not use NOR flash to boot. > The initial bring-up assumes that U-Boot is directly loaded into SDRAM > using USB boot tool, and starts from 0x80100000. > > About USB boot tool > ------------------- > > Jz4740 is one of the XBurst processors with USB boot functionality > supported. The CPU can boot from a small ROM in the LSI, initialize > CPU and USB module, then wait for USB commands from the USB host. > We can send 8 KB binary data to the CPU cache using USB boot tool. > > USB boot tool is available to the public at Ingenic website. Also > there is an alternative Debian package named xburst-tools. > > Signed-off-by: Xiangfu Liu <xian...@openmobilefree.net> > Acked-by: Daniel <z...@ingenic.cn> > Signed-off-by: Shinya Kuribayashi <skuri...@pobox.com> > --- > > Changes since v6: > > * <nanonote.h> config files is folded into <qi_lb60.h> > > * Following configs are deleted: > CONFIG_SYS_64BIT_VSPRINTF > CONFIG_NANDBOOT_CFG > CONFIG_QI_LB60 > > MAINTAINERS | 4 + > MAKEALL | 4 +- > board/qi/qi_lb60/Makefile | 45 +++++++++ > board/qi/qi_lb60/config.mk | 31 +++++++ > board/qi/qi_lb60/qi_lb60.c | 104 +++++++++++++++++++++ > board/qi/qi_lb60/u-boot.lds | 61 +++++++++++++ > boards.cfg | 1 + > include/configs/qi_lb60.h | 210 > +++++++++++++++++++++++++++++++++++++++++++ > 8 files changed, 459 insertions(+), 1 deletions(-) > create mode 100644 board/qi/qi_lb60/Makefile > create mode 100644 board/qi/qi_lb60/config.mk > create mode 100644 board/qi/qi_lb60/qi_lb60.c > create mode 100644 board/qi/qi_lb60/u-boot.lds > create mode 100644 include/configs/qi_lb60.h
Checkpatch says: total: 1 errors, 12 warnings, 478 lines checked Please clean up and resubmit. Thanks. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de You humans have that emotional need to express gratitude. "You're welcome," I believe, is the correct response. -- Spock, "Bread and Circuses", stardate 4041.2 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot