On Sat, Oct 10, 2009 at 7:45 PM, Dustin Kirkland <[email protected]> wrote: > On Fri, Oct 9, 2009 at 8:10 PM, Joseph Salisbury > <[email protected]> wrote: >> I don't believe that my node was found. But then again, I never told >> the Cluster what my nodes IP address(Or MAC Address) was, so how could >> it know how to address it? During the Cluster installation, I >> specified some Virtual IP Addresses that will be used(Step 26 of >> UEC-001), but nothing specific to a node. Should the be a step in >> UEC-003 to do something like: sudo euca_conf -addnode >> IP_ADDRESS_OF_NODE ? > > You node should have been installed to use DHCP.
During the Node installation, I canceled the DHCP request, so I could configure interface eth0 with a static IP address. Should I not have configured the interface as a static IP address? If so, would the Node have gotten one of the virtual IP addresses specified during the Cluster install? What if there is another DHCP server on the same network? Do the Nodes need to be on a private net with the Cluster? > > After installation, it should be broadcasting that its a eucalyptus > node by avahi. > > The discover-nodes command should pick up that avahi broadcast, and > detect the ip address, and prompt you to add the node. > > If that's not working, there's probably a bug somewhere. Maybe this is also related to bug: https://bugs.edge.launchpad.net/ubuntu/+source/eucalyptus/+bug/446023 The Node is not acessable via the network using the static IP address I configured(After canceling the DHCP request). I can run a wireshark trace to check if the Node is broadcasting that it is a eucalyptus node by avahi.. I can also try to re-install the Node and let it grab an IP address via DHCP. > > :-Dustin > -- ubuntu-server mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-server More info: https://wiki.ubuntu.com/ServerTeam
