Sorry, forgot at attach the file
SDRAM 8 Mbyte Booting (may take some time)... Test SDRAM OK.
Low Level Init Done... U-Boot 1.1.6 (Dec 7 2009 - 12:50:51) U-Boot code: A0780000 -> A079E6AC BSS: -> A07D56EC IRQ Stack: a075ef7c FIQ Stack: a075cf7c RAM Configuration: Bank #0: a0000000 8 MB Flash: 4.5 MB In: serial Out: serial Err: serial Hit any key to stop autoboot: 0 Booting from TFTP (may take some seconds) First loads Image and then romfs.img emac: found SMSC LAN8700 PHY emac: link status = 100Mbps, full duplex emac: MAC address = 0:1a:f1: 0: 0: 0 TFTP from server 192.168.0.113; our IP address is 192.168.0.118 Filename 'Image'. Load address: 0xa0008000 Loading: T T ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ############################################################ done Bytes transferred = 1968736 (1e0a60 hex) TFTP from server 192.168.0.113; our IP address is 192.168.0.118 Filename 'romfs.img'. Load address: 0xa0400000 Loading: ################################################################# ################################################################# ################################################################# ################################################################# ##################################### done Bytes transferred = 1517568 (172800 hex) ## Starting application at 0xA0008000 ... ŮLinux version 2.6.21-uc0 (r...@vmalexey) (gcc version 3.4.4) #185 PREEMPT Thu Oct 22 12:32:30 YEKST 2009 CPU: NXP-LPC2468 [1600ff35] revision 5 (ARMvundefined/unknown), cr=a01e8a60 Machine: lpc2468, test board Built 1 zonelists. Total pages: 2032 Kernel command line: root=/dev/ram initrd=0xA0400000,2000K console=ttyS0,115200N8 PID hash table entries: 32 (order: 5, 128 bytes) LPC2XXX Clocking Fin=12.0MHz Fcco=384MHz M=15 N=0 Fcclk=64.0MHz PCLKSEL=55515555 11555455 MAMTIM=3 MAMCR=2 Console: colour dummy device 80x30 Dentry cache hash table entries: 1024 (order: 0, 4096 bytes) Inode-cache hash table entries: 1024 (order: 0, 4096 bytes) Memory: 8MB = 8MB total Memory: 4072KB available (1736K code, 198K data, 104K init) Mount-cache hash table entries: 512 NET: Registered protocol family 16 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 512 (order: 0, 4096 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 512 bind 1024) TCP reno registered checking if image is initramfs...it isn't (bad gzip magic numbers); looks like an initrd Freeing initrd memory: 2000K io scheduler noop registered (default) framebuffer driver v.1.0 lcd_hw_init Found WG12864 Console: switching to mono frame buffer device 16x8 fb0: WG12864 device, KS0108 contr., 1K of video memory @ 0xa05e5000 Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0xe000c000 (irq = 6) is a 16550A serial8250.0: ttyS1 at MMIO 0xe0010000 (irq = 7) is a 16550A serial8250.0: ttyS2 at MMIO 0xe0078000 (irq = 28) is a 16550A serial8250.0: ttyS3 at MMIO 0xe007c000 (irq = 29) is a 16550A RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) lpc2xxx_eth_probe lpc2xxx_eth_setup get_mac_address ethaddr=00:1a:f1:00:00:00 eth0: Link down. eth0: LPC2xxx ethernet at 0xffe00000 int=21 10-FullDuplex (00:1a:f1:00:00:00) eth0: SMSC LAN8700 PHY at 31 lpc24xx-ohci lpc24xx-ohci: LPC24xx OHCI lpc24xx-ohci lpc24xx-ohci: new USB bus registered, assigned bus number 1 lpc24xx-ohci lpc24xx-ohci: irq 22, io mem 0xffe0c000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usbcore: registered new interface driver usbhid drivers/usb/input/hid-core.c: v2.6:USB HID core driver mice: PS/2 mouse device common for all mice lpc2xxx-rtc lpc2xxx-rtc: rtc core: registered lpc2xxx-rtc as rtc0 lpc2xxx-rtc: RTC driver for NXP LPC2XXX. TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 15 lpc2xxx-rtc lpc2xxx-rtc: setting the system clock to 2009-12-18 14:16:34 (1261145794) RAMDISK: romfs filesystem found at block 0 RAMDISK: Loading 1482KiB [1 disk] into ram disk... done. VFS: Mounted root (romfs filesystem) readonly. Welcome to ____ _ _ / __| ||_| _ _| | | | _ ____ _ _ _ _ | | | | | | || | _ \| | | |\ \/ / | |_| | |__| || | | | | |_| |/ \ | ___\____|_||_|_| |_|\____|\_/\_/ | | |_| For further information check: http://www.uclinux.org/ mci-cid (SD memory card): Manufacturer ID: 0x02 OEM/Application ID: TM Product Name: SD01G Product Revision: 3.2 Serial Number: 0x953e231a Date Code: 2007.5 sector size = 512 (Bytes), card size = 994 (MBytes) dump csd data: 005d00325b5983b2 ffffff8016400080 mmc: mmc1 mmc: mmc1 eth0: Link now 100-FullDuplex g_file_storage gadget: File-backed Storage Gadget, version: 28 November 2005 g_file_storage gadget: Number of LUNs=1 g_file_storage gadget-lun0: ro=0, file: /dev/mmca1 #
_______________________________________________ uClinux-dev mailing list uClinux-dev@uclinux.org http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by uclinux-dev@uclinux.org To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev