I've posted this message here although I don't think the problem is
specific to v3.10.  The issue has been intermittent but persistent even
after upgrading fro earlier versions in the hope I've fixed it.  What
happens is that periodically the sound stops even though everything else
seems to be working fine.  It usually comes about as a result of me
pausing the music but then, when I reboot, it does not come back until I
have rebooted several times. 

My setup is an Rpi2 with an IQaudio DAC and IQaudio Amp with a 7" screen
and IR control.  

I have done some analysis and the dmseg logs are different between the
no-sound and sound situations.  Those logs are the same up to 4.3
seconds.  Then there is a gap and at 13 seconds the logs differ.  In the
no-sound condition these lines appear.

[   13.124965] snd-rpi-iqaudio-dac soc:sound: ASoC: CODEC DAI
pcm512x-hifi not registered
[   13.124979] snd-rpi-iqaudio-dac soc:sound: snd_soc_register_card()
failed: -517
[   13.127941] snd-rpi-iqaudio-dac soc:sound: ASoC: CODEC DAI
pcm512x-hifi not registered
[   13.127956] snd-rpi-iqaudio-dac soc:sound: snd_soc_register_card()
failed: -517

then this - common to both conditions -

[   13.190648] snd-rpi-iqaudio-dac soc:sound: pcm512x-hifi <->
3f203000.i2s mapping ok
[   13.193308] snd-rpi-iqaudio-dac soc:sound:
snd_rpi_iqaudio_gpio_unmute: un-muting amp using GPIO22
[   13.270772] random: nonblocking pool is initialized
[   13.328793] usbcore: registered new interface driver rtl8192cu
[   13.947555] lirc_rpi: auto-detected active low receiver on GPIO pin
25
[   13.949236] lirc_rpi lirc_rpi: lirc_dev: driver lirc_rpi registered
at minor = 0
[   13.949250] lirc_rpi: driver registered!
[   14.015327] FAT-fs (mmcblk0p1): Volume was not properly unmounted.
Some data may be corrupt. Please run fsck.
[   14.060536] smsc95xx 1-1.1:1.0 eth0: hardware isn't capable of remote
wakeup
[   25.332362] input: lircd as /devices/virtual/input/input1
[   25.411583] pcm512x 1-004c: No SCLK, using BCLK: -2
[   26.853719] pcm512x 1-004c: No SCLK, using BCLK: -2

then, no-sound only condition
[   26.865528] pcm512x 1-004c: Failed to remove standby: -5
[   26.865542] pcm512x 1-004c: ASoC: Failed to turn on bias: -5

then, both conditions
[   26.899233] pcm512x 1-004c: No SCLK, using BCLK: -2


I'm not sure why it randomly stops producing sound.  Might something be
causing this intermittent fault to occurs and if so, any suggestions how
I might fix it?

thanks


------------------------------------------------------------------------
kingswindsor's Profile: http://forums.slimdevices.com/member.php?userid=61926
View this thread: http://forums.slimdevices.com/showthread.php?t=106755

_______________________________________________
unix mailing list
unix@lists.slimdevices.com
http://lists.slimdevices.com/mailman/listinfo/unix

Reply via email to