paul- wrote: > The GPIO will be in the default state as defined by the raspberry pi > firmware, until squeezelite initializes and then set the output to the > correct state. Take a look here. > > https://www.raspberrypi.com/documentation/computers/configuration.html#changing-the-default-pin-configuration
Thanks Paul, will read, first scan of the document and the Broadcom document referred to I have to choose wisely that not during power up and boot the pin changes states, pull low to high etc otherwise the relay to switch the PSU starts rattlingÂ….:-) Well, any way, will take out my proto board and test. does the all-black SB sound better than the white SB? ------------------------------------------------------------------------ hsmeets's Profile: http://forums.slimdevices.com/member.php?userid=9716 View this thread: http://forums.slimdevices.com/showthread.php?t=114828
_______________________________________________ unix mailing list unix@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/unix
