OK New version with error checking, and also addresses the issue where Klaus could not compile:
on exportScaledImage pSourceFile, pDestFile, pScaleFactor, pFormat -- Validate parameters -- pSourceFile if not there is a file pSourceFile then \ answer error "Source file does not exist!" as sheet ; exit exportScaledImage set the itemDelimiter to "/" -- pDestFile if not there is a folder (item 1 to -2 of pDestFile) then \ answer error "Destination folder does not exist!" as sheet ; exit exportScaledImage -- pScaleFactor if not (pScaleFactor is a number) or not(pScaleFactor <1) then \ answer error "Scale factor must be a percentage > 0!" as sheet ; exit exportScaledImage -- pFormat if not (pFormat is among the items of "JPEG/BMP/PNG") then \ answer error "Valid formats are: JPEG, BMP or PNG." as sheet ; exit exportScaledImage -- set the source file as the template image and get dimensions set the filename of the templateimage to pSourceFile put the formattedwidth of the templateimage into tFW put the formattedheight of the templateimage into tFH -- scale the image to a round value set the width of the templateimage to round(tFW * (pScaleFactor /100)) set the height of the templateimage to round(tFH * (pScaleFactor /100)) -- convert file switch pFormat case "JPEG" put "export the templateimage to file " & quote & pDestFile & quote & " as JPEG" into tCommand break case "BMP" put "export the templateimage to file " & quote & pDestFile & quote & " as BMP" into tCommand break case "PNG" export the templateimage to file (pDestFile) as PNG put "export the templateimage to file " & quote & pDestFile & quote & " as PNG" into tCommand break end switch do tCommand -- reset reset the templateimage end exportScaledImage > On Oct 31, 2019, at 08:00 , Bob Sneidar <bobsnei...@iotecdigital.com> wrote: > > Or better yet: -- No error checking, assumes parameters are correct. Also not > tested. :-) > > on exportScaledImage pSourceFile, pDestFile, pScaleFactor, pFormat > ## My good ol' banana, older users of MC might remember that one :-D > set the filename of the templateimage to pSourceFile > > ## This was a know (to me) feature > put the formattedwidth of the templateimage into tFW > put the formattedheight of the templateimage into tFH > ## Now you can apply some "rule of three" to scale the image while > preserving its ratio > ## I'll leave that up to you... :-) > > ## I cheated a bit: > set the width of the templateimage to round(tFW * (pScaleFactor /100)) > set the height of the templateimage to round(tFH * (pScaleFactor /100)) > > ## But this one really suprised me: > switch pFormat > case "JPEG" > export the templateimage to file (pDestFile) as JPEG > break > case "BMP" > export the templateimage to file (pDestFile) as BMP > break > case "PNG" > export the templateimage to file (pDestFile) as PNG > break > end switch > > reset the templateimage > end exportScaledImage > > >> On Oct 30, 2019, at 13:13 , Klaus major-k via use-livecode >> <use-livecode@lists.runrev.com> wrote: >> >> Hi all, >> >> we know that "the templatexxxxxx" is a very helpful thingie. >> >> But I was really surprised that we can even EXPORT something >> from the templateimage until I tried this: > <snip> _______________________________________________ use-livecode mailing list use-livecode@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-livecode