Hi Members ,
I am trying to run the testpmd command on a x86_64 machine .
Have shared the log's of
- Command testpmd
- Command devbind
- Steps i followed to get the dpdk source code compiled on host
~ : sudo dpdk-testpmd -l 0-3 -n 4 -- -i --nb-cores=2
EAL: Detected 32 lcore(s)
EAL: Detected 1 NUMA nodes
EAL: Detected static linkage of DPDK
EAL: Multi-process socket /var/run/dpdk/rte/mp_socket
EAL: Selected IOVA mode 'PA'
EAL: No available 1048576 kB hugepages reported
EAL: VFIO support initialized
EAL: Probe PCI driver: net_bnxt (14e4:16d8) device: 0000:c6:00.1 (socket 0)
bnxt_hwrm_send_message(): Error(timeout) sending msg 0x0000, seq_id 0
bnxt_hwrm_ver_get(): failed rc:-110
ethdev initialisation failed
EAL: Requested device 0000:c6:00.1 cannot be used
TELEMETRY: No legacy callbacks, legacy socket not created
testpmd: No probed ethernet devices
Interactive-mode selected
testpmd: create a new mbuf pool <mb_pool_0>: n=171456, size=2176, socket=0
testpmd: preferred mempool ops selected: ring_mp_mc
Done
testpmd> set fwd txonly
Set txonly packet forwarding mode
testpmd> start
txonly packet forwarding - ports=0 - cores=0 - streams=0 - NUMA support
enabled, MP allocation mode: native
txonly packet forwarding packets/burst=32
packet len=64 - nb packet segments=1
nb forwarding cores=2 - nb forwarding ports=0
testpmd>
testpmd> stop
Telling cores to stop...
Waiting for lcores to finish...
+++++++++++++++ Accumulated forward statistics for all
ports+++++++++++++++
RX-packets: 0 RX-dropped: 0 RX-total: 0
TX-packets: 0 TX-dropped: 0 TX-total: 0
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Done.
B) I have the the device binding
# dpdk-devbind.py -s
Network devices using DPDK-compatible driver
============================================
0000:c6:00.1 'BCM57416 NetXtreme-E Dual-Media 10G RDMA Ethernet
Controller 16d8' drv=uio_pci_generic unused=bnxt_en,vfio-pci
C) The dpdk was compiled using below step:
git clone https://dpdk.org/git/dpdk
cd dpdk/
pip3 install meson
pip3 install pyelftools
pip3 install ninja
meson -Dexamples=all build
ninja -C build
cd build
ninja install
ldconfig
mkdir -p /dev/hugepages
mountpoint -q /dev/hugepages || mount -t hugetlbfs nodev
/dev/hugepages
bash -c 'echo 2048 >
/sys/kernel/mm/hugepages/hugepages-2048kB/nr_hugepages'
Can a senior member please help me as I am learning things here .
And getting working setup is very important for someone like me who is
starting new here
Thanks ,
Ashish
