Christos
This might help...
This is out of the Nokia Premicell Data Book
AT+CNMI
AT+CNMI = <mode>,<mt>,<bm>,<ds>,<bfr>
<mode>
0 Buffer all indications in unit
1 No indications when link is reserved ( on line data mode )
2 Buffer indication when link is reserved and flush them to the DTE after
reservation has ended
<mt>
0 No received message indication are sent to DTE
1 Indication are send to DTE using +CMTI
2 Messages ( class 2 ) are routed directly to DTE using +CMT others +CMTI
3 As above but class 3 results in a +CMT others +CMTI
<bm>
0 No cell broadcast are routed to the DTE
2 They are
<ds>
0 No status reports are send to the DTE
1 They are
<bfr>
0 Data buffer indications are flushed to the DTE when <mode> is 1 or 2.
1 Data buffer indocations are cleared when <mode> is 1 or 2.
-------------------------
This is from the Ericsson GM 12 integrators manual
AT+CNMI <mode>,<mt>,<bm>,<ds>
<mode>
3 All result codes are routed to DTE
<mt>
0 No Indications are routed to the DTE (default)
1 Indications are routed to the DTE using +CMTI
3 As above ( Class 3 ) using +CMT all others +CMTI
<bm>
0 No indication of CB are routed to DTE
2 They are
<ds>
0 No status reports are routed to the DTE
Hope that helps
-Chris B
Christos Stieglitz wrote:
>
> Hi,
>
> i'm able to send and receive SMS via the fake service and able to send SMS via
> a Siemens S25 mobile phone.
> Kannel does not notice anything every time an SMS arrives on the phone :-(
>
> I changed the AT+CNMI command parameters (in smsc_at.c) from "1,2,0,0,0" to
> "1,0,0,0,1" as Siemens documentation implies. Unfortunately without any success.
>
> What else should i try? Any hints? Thank you in advance
>
> Christos Stieglitz