Hello all, I've recently returned to the world of OpenSAF after working on some other stuff. In the time I was diverted OpenSAF moved from 1.0-2 to 1.0-4. After upgrading my OpenSAF installation I'm seeing some problems using the avsv CLI, namely:
# /opt/opensaf/controller/bin/ncs_cli_maa cli idle time is 300 seconds ncs cli user is an authenticated super user. NCS>enable NCS#configure terminal NCS-config#avsv NCS-config-avsv#set safNode=PL_2_4 adminstate unlocked MIB_ARG PP @ address b4dbe7f0 ================================= Op: SET Req, Tbl Id: 11, Exch Id: 0 User Key: 4288675841 MIB Key: 4288675841 Source: 4 Index vals as int: , 14, 115, 97, 102, 78, 111, 100, 101, 61, 80, 76, 95, 50, 95, 52 Index vals as ascii: , , s, a, f, N, o, d, e, =, P, L, _, 2, _, 4 Param Val: Id 4, Integer, Val 2 IN LEAP_DBG_SINK: line 518, file ./src/hj_mib.c IN LEAP_DBG_SINK: line 253, file ./src/hj_mib.c FAILURE: State could not set ..... Command Execution Function failed ..... Basically, all 'set' commands give the same error. This seems fairly 'random' at the moment, in that if I reboot OpenSAF on all nodes (inc. controller), next time the same commands work. It seems to be happening about 1/2 the time I start OpenSAF. Any ideas on how to diagnose what's causing it? Thanks and regards, John _______________________________________________ Users mailing list [email protected] http://list.opensaf.org/maillist/listinfo/users
