Hello Bogdan, Thank you very much for your quick response. Here I have attached OpenSIPs call log.
-Urmi On Tue, Aug 25, 2009 at 3:54 PM, Bogdan-Andrei Iancu <bog...@voice-system.ro > wrote: > Looks good - can you post the opensips logs (in debug=6) for this single > call ? just to verify. > > Regards, > Bogdan > > urmi lakkad wrote: > > Hello Bogdan, > > > > Thank you for ur response. > > > > Here with this mail I have _attached my SIP call capture_ using ngrep. > > So, please find the attachment. and do needful. > > > > > > -Thanks > > Urmi > > > > On Tue, Aug 25, 2009 at 12:41 PM, Bogdan-Andrei Iancu > > <bog...@voice-system.ro <mailto:bog...@voice-system.ro>> wrote: > > > > Post the SIP capture of the call you are testing with. Use "ngrep > > -d any > > . port 5060" to get the capture - this will solve the mystery. > > > > Regards, > > Bogdan > > > > urmi lakkad wrote: > > > Hello, > > > > > > Can u please suggest me some solution of my problem of DIALLOG > > module ? > > > > > > Thank you for your attention. > > > > > > -Urmi > > > > > > 2009/8/21 urmi lakkad <urmi.lak...@gmail.com > > <mailto:urmi.lak...@gmail.com> > > > <mailto:urmi.lak...@gmail.com <mailto:urmi.lak...@gmail.com>>> > > > > > > Hello Brett, > > > > > > Thank you very much for quick response. > > > > > > My calls are working fine. I have checked through SIPp and also > > > with Grandstream Phones. The call is working fine with out > > > failure. At the time of call, I have started the wireshark to > > > capture the packets, but there also I m not getting any negative > > > reply like 400 or 300. > > > > > > See, my call is working fine, call dialog created successfully, > > > but after that it destroyed, again new dialog is created n that > > > too destroy. For a single call it creates 2 dialogs. But that > > > dialog entry is not going to DB. Please suggest me the right thing > > > to do. > > > > > > Thanks a lot for your attention. > > > > > > > > > -Urmi > > > > > > > > > > > > On Thu, Aug 20, 2009 at 7:38 PM, Brett Nemeroff > > > <br...@nemeroff.com <mailto:br...@nemeroff.com> > > <mailto:br...@nemeroff.com <mailto:br...@nemeroff.com>>> wrote: > > > > > > Urmi, > > > You log shows the call having failed. I'm not sure why you > > > think it runs for the proper duration. But as far as OpenSIPs > > > is concerned, the call failed. It's likely a problem in your > > > sipp scenario. It's very possible that sipp thinks the call is > > > up, but the proxy does not. > > > > > > In any case, OpenSIPs is behaving as expected, the call fails, > > > the dialog is destroyed. > > > Aug 19 17:46:27 [6060] DBG:dialog:next_state_dlg: dialog > > > 0x2aaaad55af90 changed from state 1 to state 5, due event 1 > > > Aug 19 17:46:27 [6060] DBG:dialog:dlg_onreply: dialog > > > 0x2aaaad55af90 > > > failed (negative reply) > > > > > > BTW, a negative reply is >=400 (or may also include >= 300, > > > can't remember). Check your traces, see where that comes from. > > > -Brett > > > > > > On Thu, Aug 20, 2009 at 9:02 AM, urmi lakkad > > > <urmi.lak...@gmail.com <mailto:urmi.lak...@gmail.com> > > <mailto:urmi.lak...@gmail.com <mailto:urmi.lak...@gmail.com>>> > wrote: > > > > > > Hello Stanisław Pitucha, > > > > > > Thank you for support. > > > > > > No, My call is established perfectly and is running for > > > the specified duration without fail. > > > I m firing the call using SIPp. > > > > > > Also, the dialog state gives me 1. > > > > > > Thanks for ur attention. > > > > > > -Urmi > > > > > > 2009/8/20 Stanisław Pitucha <virap...@gmail.com > > <mailto:virap...@gmail.com> > > > <mailto:virap...@gmail.com <mailto:virap...@gmail.com>>> > > > > > > 2009/8/20 urmi lakkad <urmi.lak...@gmail.com > > <mailto:urmi.lak...@gmail.com> > > > <mailto:urmi.lak...@gmail.com <mailto:urmi.lak...@gmail.com>>>: > > > > Am I doing right or not ? If not, please tell me the > > > correct way. > > > > One more thing, Is my configuration is correct or not ?? > > > > > > It looks like your call doesn't even get accepted: > > > Aug 19 17:46:27 [6060] DBG:dialog:next_state_dlg: dialog > > > 0x2aaaad55af90 changed from state 1 to state 5, due > > > event 1 > > > Aug 19 17:46:27 [6060] DBG:dialog:dlg_onreply: dialog > > > 0x2aaaad55af90 > > > failed (negative reply) > > > > > > Maybe you require authentication, or something else? > > > Just take care of > > > the call not failing first. So far it's rejected > > > before an OK answer > > > (state 1 is "after sending an INVITE", state 5 is > > > "deleted" - more or > > > less). > > > Capture the traffic and see what's going on. >
_______________________________________________ Users mailing list Users@lists.opensips.org http://lists.opensips.org/cgi-bin/mailman/listinfo/users