Hi Laszlo
I can see this error in the syslog error: Got `remove' command from OpenSIPS for unknown session with call-id `ca8ccd95-d81511e2-bebfd582-e4ab...@xx.xx.xx.xx-b2b_ please can you show me how I can do the uac_replace per branch ,in other words from where and how I can remove the uac_replace_to from global since second time I am doing it in a branch Regard From: users-boun...@lists.opensips.org [mailto:users-boun...@lists.opensips.org] On Behalf Of Laszlo Sent: Wednesday, June 19, 2013 4:24 PM To: OpenSIPS users mailling list Subject: Re: [OpenSIPS-Users] uac_replace_to problem BTW, looks like you doing uac_replace_to twice. once in global, and once in a per-branch route. You can do it only once, I'm sure you see something about this in the syslog. try what Flavio suggested, so do these changes only in the branch route. -Laszlo 2013/6/19 M.Khaled W Chehab <kche...@icucall.com> while i am using uac_replace_to in failover route branch i can find that TO header is not changed(sip user part ) but appended an new raw as I want it to be To: "971552448304" <sip: 808971552448...@xx.xx.xx.55> SIP to address: sip:835822971552448...@xx.xx.xx.55sip:808971552448...@xx.xx.xx.55 SIP to address User Part: 835822971552448304 SIP to address Host Part: xx.xx.xx.55sip SIP to address Host Port: 808971552448...@xx.xx.xx.55 please advice regards From: M.Khaled W Chehab [mailto:kche...@icucall.com] Sent: Wednesday, June 19, 2013 2:41 PM To: users@lists.opensips.org Cc: users-boun...@lists.opensips.org Subject: uac_replace_to problem Hi, I am running opensips 1.8.3 with do_routing module A dial_rule prefix has 3 trunk gateways ( gw1,gw2,gw3) After do_routing(,) I am setting the $rU and fixing the To Tag header using uac_replace_to( and the call go to gw1 with correct TO tag as I set it , but when calls fails on gw1 ,then I set the $rU in route[6] to go to second in route and it goes with bad TO header, since it goes with the same To header in the 1st invite That target gw1 1-how to fix the To header in the second invite to gw2 loadmodule "uac.so" modparam("uac","restore_mode","auto") uac_replace_to("$avp(dst)","sip:$var(prefix)$avp(dst)@$td"); t_on_failure("1"); on failure_route[1] { . if (!t_check_status("487")) { #xlog("------------route6-------\n"); $avp(failure_count) = $avp(failure_count) + 1; #480|486|603 route(6); } Route[6]{ . . . $rU = $var(prefix) + $avp(dst); uac_replace_to("sip:$var(prefix)$avp(dst)@$td"); } Regards _______________________________________________ Users mailing list Users@lists.opensips.org http://lists.opensips.org/cgi-bin/mailman/listinfo/users
_______________________________________________ Users mailing list Users@lists.opensips.org http://lists.opensips.org/cgi-bin/mailman/listinfo/users
